hello!Welcome to MotoSleep!

Product center

We have over 15 years experience producing high quality DC motors for furniture, lift chairs and exercise equipment. We build our motors, not simply assemble components.

The basic parameters

H200– Wireless Power Foundation
Sizes available: King, Cal King, Queen, TXL, & Cal TXL

 ·Head position adjustment
·Foot position adjustment
·One touch return to "flat" position
·Preset buttons: TV viewing position/Zero gravity position/Anti-snore position
·LED under bed lighting
·2 programmable memory settings
·Wireless hand control with blue backlights
·Built-in USB charging ports
·Fully upholstered base and surround
·Works with head-foot-rail or headboard only beds
·ncludes headboard mounting brackets
·King size can be synchronized or independent function
·Tested / 650LBS weight capacity @ 15,000 cycle
·Emergency battery back up built in to power supply

 Load ability:
·TXL: 144 Units/40ft Container
·Queen: 93 Units/40ft Container
·King: 68 Units/40ft Container
  

Installation and Setup Guide
1. Open the box labeled 'King Foot Base'. Take the Foot Base out of the box and put in on a flat floor.
   
2. Open the box labeled 'King Head Base'.
   
3. Cut the white tie securing the mattress retainer bar as well as the ribbon securing the accessory boxes and dispose of them  properly. Set the boxes aside for now. Note: do not pull the ribbon from the base as the upholstery will be damaged.

   
   
4. Take the Head Base out of the box and put it in front of the Foot Base. With two people, make sure the sides of the Foot Base and Head Base are lined up straight with each other.



5. Take the plastic bag out of the accessory box where there is a wrench (13mm) and 4 bolts for the connecting components.




6. Plug the Foot motor cable into the control box plug labeled FT Motor. If there is a LED, plug the LED cable into the control box plug labeled LED. If there is a massage feature, plug the FT massage cable into the control box plug labeled FT massage.





7. Take the 7 adjustable legs from the main accessory box and screw them into the frame bottom tubes.



8. The assembly job is finished. To turn the bed over, you need to have two people. Once the bed is turned over, get the two mattress retainer bars you set aside earlier and slide them into the plastic retainers on the foot end of the bed.



9. Remove the power supply from the main accessory box. Plug the power cable from the control box into the power supply. Plug the power cable that was packaged with the power supply into the power supply. Plug the power supply into a power source. Install 3 AAA batteries in the remove control.



10. Check every function on the remote control before you install a mattress or put inside an existing bed frame.




Copyright 2016 HHC Changzhou Corp All Rights Reserved Design:EastNet [Manage]